Ship Bio- Star Trek's USS Enterprise NCC-1701-E
The USS Enterprise NCC1701-E was a Sovereign class starship, launched in 2372 from the San Francisco Fleet Yards under the command of Captain Jean-Luc Picard, and most of the key officers from the Enterprise-D which was destroyed a couple of years earlier in a battle with a Klingon Bird of Prey over Veridian III. It was the sixth Federation starship in a long lineage of ships to carry the name "Enterprise"
Originally, the Enterprise-E was just under 700 meters long and had 24 decks and was equipped with twelve phaser arrays and five torpedo tubes.
By 2379, the Enterprise-E had undergone at least one refit, including four additional phaser arrays and five additional torpedo tubes. The number of decks was also increased by five to a minimum of 29.
Sections included deflector control, stellar cartography, hydroponics (on deck 11), and one sickbay ward. Main engineering and sickbay were on Deck 16.
Mass 3,205,000 metric tons
Length 685.7 meters
Width 250.6 meters
Height 88.2 meters
16 phaser arrays
1 forward quantum torpedo launcher
3 forward photon torpedo launchers
6 aft photon launchers
Seven dorsal phaser arrays were located on the primary hull, one extending around the saucer section, giving it an oval appearance. Six smaller arrays covered the aft dorsal firing arcs and were located along the aft portion of the saucer section, above the main shuttlebay.
Four ventral phaser arrays were located on the primary hull, extending around in nearly a half circle on both the starboard and port ventral sides of the saucer section. A single phaser array was located along the ventral section of the engineering hull, running perpendicular to the hull.
During one of the refits, four phaser arrays were added to the trailing edges of the warp nacelle pylons (one dorsal and one ventral for each pylon) bringing the phaser array count to a total of sixteen.
The Sovereign-class mounted five torpedo launchers. The "main" launcher was located on the ventral portion of the saucer on a turret and was supplemented by one twin-tube launcher, forward and aft at the bottom of the secondary hull. The refit saw the addition of five more tubes: three on the dorsal saucer section (a single tube facing forward on deck 3 and a twin-tube launcher facing aft located above the aft saucer airlock) as well as two on the secondary hull, both facing aft – one above and one below the secondary hull shuttlebay.
In terms of deck layout, the upper sections of the Sovereign-class starship formed the command section and living areas, while the lower decks housed main engineering and fuel supplies.
As is traditional, deck numbering ascended from top to bottom. At the top of the saucer section was Deck 1, which housed the main bridge. This deck also held the more recent modifications of an observation lounge, a ready room for the ship's captain, and an airlock with attached cabin.
Deck 2 encompassed the first of the many levels of crew quarters, with rooms for the highest-ranking command staff and an officer's mess hall. Decks 3 through 9 featured more officers' quarters, the forward and aft viewing lounges, science labs, the main shuttlebay, conduits for the optical data network, and the vessel's main computer core.
Decks 10 through 14 completed the primary hull of the Sovereign-class starship, and also encompassed forward and aft cargo bays on decks 10 and 11, and phaser systems on deck 11. The stellar cartography department aboard the Sovereign-class was located on deck 11. Sensors and the secondary navigational deflector were found on deck 12.
Deck 13 was taken up almost entirely by deuterium fuel tanks. This marked the real split between the habitable areas and the engineering and ship's storage sections. Main engineering and its related systems – such as the EPS power taps, the central matter/antimatter reaction chamber, support labs, and the engineering computer core – were spread over decks 14 through 18.
Deck 14 was largely dedicated to engineering systems, and also featured the lower sensor platform. Decks 15 through 18 comprised the main navigational deflector array and an auxiliary bridge, which was also known as the battle bridge.
Deck 16 also featured the launch and retrieval mechanism for the captain's yacht. The yacht was lowered by a set of gantries until its engines extended to operational position and then it would be free to maneuver.
The Sovereign-class was also equipped with an astrometrics lab where a direct uplink with Starfleet Cartography could be established. One flaw in this system was that interference from nearby astronomical phenomena could interfere with the link to Starfleet's stellar cartography system.
Command and control systems consisted of a bio-neural gel pack-based computer system that were concentrated in two computer cores. The primary core was located directly below the main bridge on decks 6 through 8. The secondary core was located in the engineering section, adjacent to environmental control, on decks 15 through 17.
Sovereign-class starships had similar warp drive capabilities of other Starfleet ships..Two warp nacelles at the aft of the drive section, which housed multiple pairs of warp coils.
There were also two impulse engines (for sublight propulsion) located at the aft of the saucer section.
Primary operational control of the ship was in the main bridge located at the top of the primary hull. The bridge controlled all primary mission operations and all departmental activities on the ship.
The central area of the main bridge provided seating and computer displays for the captain and two other officers. The captain's chair was raised from the rest of the bridge officers to the height of the surrounding level, which included tactical and operations. The two officer seats were equipped with fully programmable consoles for a variety of uses.
Directly in front of the command area was the conn officer, who faced the main viewer. To the port side of the conn officer, also facing the main viewscreen, was the operations officer's console, which was identical in size and design to the helm station.
At the very front of the bridge chamber was a large viewscreen. When the screen was not active, a standard bulkhead was present.
Aft and to the left of the command area was an elevated platform on which tactical and security consoles were located. To the captain's right, behind the tactical console, was the mission operations section of the bridge. Against the starboard side walls of the main bridge were the consoles for sciences, along with others that were programmable for a multitude of functions.
Located against the aft wall of the bridge was a large master systems display monitor, similar to the one in engineering. All relevant ship information (such as damage, power distribution, etc.) could be displayed on this cutaway image of the vessel. This monitor could be used to direct ship operations and could be configured for limited flight control if necessary.
Also located against the aft wall of the main bridge was the large engineering console. This had a smaller cutaway diagram of the vessel, which displayed all engineering-relevant data and showed warp fields and engine output.
There were two turbolifts on the bridge. There was also an emergency ladder that connected the bridge to lower decks. Additionally, the bridge provided direct access to the observation lounge, which was located directly aft of the bridge, and the captain's ready room.
The captain's ready room doubled as an office and a second private cabin in addition to the commanding officer's private quarters. It was located off the starboard side of the main bridge on deck 1, and provided a place where the captain could work or rest while remaining next to the bridge in case of an emergency. Meetings between the captain and one or two people would also take place here.
In one corner there was a simple, narrow bed with a small bookcase over it. Toward the rear of the room was a desk with a computer console.
In a corner behind the desk was a doorway which led into a bathroom containing a sonic shower. Below a mirror was a sink that had no visible controls; the water came on automatically when hands were placed beneath the faucet, and went off when they were withdrawn.
Usually, the ready room would be decorated by its occupant by adding a number of personal ornaments.
Main engineering contained the controls for the warp and impulse drive systems. Entrance to the primary engineering spaces was provided by two large blast doors, a pair each deck on decks 15 and 16, that could be closed for internal or external security reasons, as well as in case of emergencies. It was much larger than on previous starship classes and was split into three levels to accommodate the warp core, which spanned several decks.
The majority of controls were situated on the main deck (deck 16) and an upper level gantry. Arranged around the warp core stack were a number of control consoles that could be reconfigured to emulate all the command controls on the bridge.
The largest work station was the master systems display, which was used to monitor the status of all key systems and could comfortably accommodate four personnel. There were also various wall displays, including a schematic that showed the 'health' of the warp propulsion system.
The deuterium tanks were above the core, while antimatter storage pods surrounded the base of the core. Two large cylindrical tanks were positioned next to the warp core and contained highly dangerous plasma coolant. Two rectangular power transfer conduits fed off from the warp reaction chamber and angle out of main engineering to the port and starboard warp nacelles. (Star Trek: Insurrection)
Additionally, there were numerous ladders and access panels to Jefferies tubes, leading throughout the starship. A second tier ringed the second level of main engineering on deck 15. Two ladders on the opposite ends of the catwalk provided access. By 2379, Starfleet began implementing a force field system around the warp reactor. The Sovereign-class was equipped with a warp core ejection system. Normally used as a last resort measure when a warp core breach was in progress.
The Sovereign-class starship included at least four separate transporter rooms, capable of site-to-site transport. Unusually, the transporter console in a Sovereign-class transporter room was built into a wall opposite the transporter platform, from where the controls on the console could be seen. The transporters could be operated from both the tactical and engineering stations on the ship's bridge. A Sovereign-class starship was capable of beaming a single small vessel – such as a Scorpion-class attack fighter – aboard, even if the smaller craft was mobile.
One large sickbay facility, located on deck 7, served as the primary care facility on Sovereign-class starships. Equipped with six standard and one advanced biobed, sickbay was also home to the chief medical officer's office and a small lab used for routine analysis of patients. (Star Trek Nemesis)
A second, smaller facility identical to an Intrepid-class sickbay was also present on deck 16
One large sickbay facility, located on deck 7, served as the primary care facility on Sovereign-class starships. Equipped with six standard and one advanced biobed, sickbay was also home to the chief medical officer's office and a small lab used for routine analysis of patients. (Star Trek Nemesis)
A second, smaller facility identical to an Intrepid-class sickbay was also present on deck 16
Located near sickbay was the counselor's office, a modest room approximately the size of a standard living room compartment.
The arrangement of living quarters was designed to be modular, so that at any time a particular area could be reconfigured to create larger or smaller residential areas. Most living areas were located on the upper and lower surfaces of the saucer section, offering residents a remarkable view of the starscape outside their windows.
As was common on Starfleet vessels, the living accommodations for senior officers and VIPs were larger than standard crew quarters. Officers' quarters usually included a living area in the center of the dwelling, which held a personal workstation, couch, replicator, and a small dining area.
Connected to this was a bedroom that featured a double-sized bed and room for personal belongings. Normally, the bedroom would be connected by a half-bathroom with wash basin, mirror, toilet, several drawers, and a sonic shower. For senior staff, this bathroom was usually upgraded to a full-sized bathroom with a bathtub.
Auxiliary spacecraft systems
Located at the dorsal stern of the primary hull, the main shuttlebay took up a significant portion of the aft section of decks 6 through 9 on the Sovereign-class. Due to the mission profile of the Sovereign, the shuttlebay extended further than normal for a vessel its size to accommodate runabouts and several shuttlecraft.
The secondary shuttlebay was located at the very aft portion of the engineering hull. This bay, while smaller than the main facility, was just as capable of handling flight operations as the main shuttlebay.
In addition to shuttlecraft, the Sovereign class also featured a captain's yacht, designed for special diplomatic missions. The yacht on board the Enterprise-E was named the Cousteau.
Escape pods
The Sovereign-class starship carried a number of escape pods. In the event of a catastrophic emergency, these pods served the same purpose as the lifeboats of a water-based vessel and ensured the continued survival of passengers and crew after the primary vessel had to be abandoned.
The escape pods were located throughout the Sovereign-class starship's primary and secondary hulls: there were two rows of pods on the dorsal side of the command saucer, and two on the ventral side. Further rows of pods lined each side of the engineering hull.
Unlike the escape pods utilized on the Galaxy- and Intrepid-class, there was no outer hatch that opened for launch. Instead, the heat shield of the escape pod lay flush with the Sovereign-class ship's outer hull. Personnel entered the pods through hatches that lined sections of the ship's corridors, and a situation display monitor was located between the pods.
Each hatch swung open on a hinge at the bottom, creating a short ramp from the floor of the corridor into the interior of the capsule. The pods were equipped with heat shields for atmospheric entry and landing if a suitable planet could be found to set down on.
The saucer section of the Sovereign class could separate from the drive section of the ship if needed.